Nearly three years ago, I posted about some fun I’d been having with VISCA using C#. As a reminder, VISCA is a camera control protocol, originally used over dedicated serial ports, but more recently over IP.

Until this week, all the cameras I’d worked with were very similar – PTZOptics, Minrray and ZowieTek all produce hardware which at least gives the impression of coming out of the same factory, with the same “base” firmware that’s then augmented by the specific company. I’ve seen differences in the past, but they’re largely similar in terms of VISCA implementation.

This week, my Obsbot Tail Air arrived. I’ve been looking at Obsbot for a while, attracted by the small form factor, reasonable price, and fun object tracking functionality. However, earlier models didn’t have the combination of the two features I was most interested: VISCA and NDI support. The Tail Air has both. I bought it in the hope that I could integrate it with my church A/V system (At Your Service) – allowing for auto-tracking and portability (as the Tail Air is battery powered and wireless).

The NDI integration worked flawlessly from the start. Admittedly the Tail Air takes a lot of bandwidth by default – I’ve turned the bitrate down to “low” in order to get to a reasonable level (which still looks great). But fundamentally it just worked.

VISCA was trickier – hence this blog post. First, there wasn’t documentation on whether it was using TCP or UDP, or which port it was listening on. To be clear, the product’s only just launched, and I’m sure the documentation will improve over time. Fortunately, there was information on the Facebook group, suggesting that other people had got some VISCA clients working with UDP port 52381.

To start with, that was going to cause a bit of a problem as my implementation only supported TCP. However, it was pretty easy to change it to support UDP; the code had already been written to isolate the transport from other aspects, at least to some extent. Fortunately, the PTZOptics camera supports both TCP and UDP, so it was easy to test the UDP implementation that way.

Unfortunately, the implementation that worked for my PTZOptics camera entirely failed for the Tail Air. After doing a bit of digging, I found out why.

It turns out that there are two variants of VISCA over IP – what I’ve called “raw” and “encapsulated”, but that’s definitely not official terminology. In the “raw” version, each message is between 3 and 16 bytes:

The “encapsulated” version uses the same data part as the “raw” version, but with an additional header of 8 bytes:

So for example, the raw command for “get power status” is 81-09-04-00-ff.

The encapsulated command for the same request (with a sequence number of 00-00-00-00) is 01-10-00-05-00-00-00-00-81-09-04-00-FF.

Once I’d figured that out (and hand-crafted the “get power status” packet to check that I was on the right lines), the rest was fairly straightforward. My VISCA library now allows the use of TCP or UDP, and raw or encapsulated format.

The Tail Air still doesn’t behave quite the same as my PTZOptics camera in terms of VISCA support, mind you:

Still, none of that should prevent fuller integration within At Your Service. I need to take account of the different pan/tilt/zoom limits within At Your Service, allowing them to be configurable, but after that I should have a reasonably workable system… as well as a handy little test camera to take for demo purposes!

All the code changes can be seen in the CameraControl directory of my demo code GitHub repo.

The Tail Air is not the only new toy I’ve received this week… I’ve also taken delivery of an Allen & Heath CQ20B digital mixer, so I’ve been playing with that today as well, trying to work out how to integrate that into DigiMixer. I’m really hoping to get a chance to write some more blog posts on DigiMixer over the Christmas holidays… watch this space.